Method 1:
Ideal Smoking Material: Small pods, loosely packed
|
 |
1. Slide Aluminum Insert Tube into VaporTech unit and turn unit on. Unit takes 4-5 minutes to reach ideal temperature.
Note! Brass Insert must not be in unit.
|
 |
2. Assemble Plastic Hose & Glass Tube. Insert tapered end of Glass Tube with the indent ring (not rubber ring) into end of the Plastic Hose.
Warning! To avoid injury from broken glass, dip the tip of the Plastic Hose into boiling water for 10 seconds. The Glass Tube is
easier to insert this way. This only needs to be done the first time you use the VaporTech (or a new plastic hose).
Loosely insert a small amount of smoking material into non-tapered end of the Glass Tube, just inside the rim. |
 |
3. Insert loaded end of Glass Tube into center of heated Aluminim Insert. |
 |
4. Begin to draw slowly after 3 seconds. Watch vapor slowly rise through the tube. Draw steadily for 10-25 secondsm
emptying the Glass Tube as it fills with vapor. Do not suck so hard that you draw solid particles up the Plastic Tube. Draw slowly enough so you can always see vapor passing though the Glass Tube.
Practice Makes Perfect!
Important! Remove Glass Tube and Plastic Hose assemply from the unit when you stop puffing. Otherwise the smoking material
continues to bake and will blacken. |
|
5. Remove used smoking material from Glass Tube. Lift Hose/Tube assembly out of VaporTech unit. Cover hole on side of Glass Tube with finger. Aim at a trashcan or ashtray, blow a short burst of air through the Plastic Hose.
The used smoking material should shoot out instantly. If it doesn't, suck it backwards and do it again. |
|
Method 2:
Ideal Smoking Material: Extreme Powder, Resin, Oils
|
 |
1. Place Aluminum Insert into VaporTech unit then turn unit on. Wait 5 minutes for unit to heat up. Put Test Tube
into unit for one minute to pre-heat it. After the Test Tube has been heated, place smoking material inside of Test Tube. |
 |
2. Assemble Plastic Hose & Glass Tube with rubber ring. Insert end of Glass Tube into the end of the Plastic Hose.
Warning! To avoid injury from broken glass, dip the tip of the Plastic Hose into boiling water for 10 seconds.
The Glass Tube is easier to insert this way. This only needs to be done the first time you use the VaporTech (or a new plastic hose). |
 |
3. Drop a very small amount of smoking material into
the Test Tube that you have pre-heated in the VaporTech unit. |
|
4. Insert Glass Tube into Test Tube.
Tip! Adjust the distance of the Glass Tube from the smoking material by raising or lowering the rubber ring. |
|
5. Draw slowly from either end of hose/tube assembly. Watch for vapor rising through the tube. The smoking material
should be completely vaped within 5-15 seconds. Remove the Test Tube (HOT!!! See warning below!) from the the heating unit as soon as you stop puffing on the hose. Otherwise the smoking material
continues to bake and will blacken. |
| |
6. Remove used smoking material from Test Tube. First, pull hose/tube assembly out of Test Tube. Lift Test Tube out of VaporTech
unit by grasping top end. Turn Test Tube upside down and allow contents to spill out. |
